A bare bones casting table to keep costs low. Requires buyer to supply their own standard size bell jar (up to 11 inch base), a vacuum pump capable of pulling enough vacuum to remove the air while investing. I suggest a 3 CFM x 2 stage pump at minimum.
***This unit does not include a vacuum gauge. A vacuum gauge is not necessary to operate but buyer can always purchase one if desired.
***Can only be shipped in a USPS Large flat rate box. Contact Craig with questions on shipping.
* Bottom has an internal trap in case person casting has a blow out but it is recommended a second inline filter be added near the pump. Internal trap must be taken apart to clean out. This is the fault of the caster but I'm willing to repair at my cost if needed.
* Top measures 11 inches in diameter (black pad). The areas for the feet stick out a bit farther.
* Black rubber pad is 1/4 inch gasket rubber custom cut to fit aluminum plate.
* 5 foot hose with quick release is included to release air when investing.
* White silicone casting pad (Picture 3) is optional and can be added below.